AQUASTOP – E-96

AQUASTOP E-96 SLOW CURE is 2:1, 100% solids, 0 VOC, two-component epoxy resin-based primer based on phenolic amine chemistry specifically designed as a moisture barrier for concrete floors with very high residual moisture prior to laying floor coverings, coatings, or parquet. (Up to 15 lbs/1,000ft2/24 hr.). Also suitable on calcium sulphate-based screeds with slightly higher residual moisture.
As a primer for absorbent, non-absorbent as well as smooth surfaces. For interior and exterior use.

Concrete slabs at ground level emit invisible moisture vapor. The permissible moisture emissions for concrete are 3 lb./1000ft2 over 24 hours (<4%) based on calcium chloride test. In addition, a relative humidity (RH) test can be performed to test for moisture vapor. Relative humidity test results should be less than 85% per ASTM F2170. If humidity is above this level, blistering and delamination of the coating may occur.

ADVANTAGES

Made from 100% solids.
Resistant to chemical loadings
Good penetration
Can be applied to almost all substrates
Grip promoting
Suitable for application on subfloor heating systems.
Resistant to bacteria and moisture
Exceeds ASTM F3010 standards
0 VOC
Suitable on damp substrates
High sealing function
For increased residual moisture and single-layer application
Magnesite screeds
Old sealed/coated surfaces
Impermeable and seamless. Up to 15 lbs/1000ft2 /24 hr.

USES

Concrete Surfaces
Decorative Chips/Flakes
Decorative Quartz
Metallic Coating System
High/Thin Build Systems
Mortars
Cementitious Overlays
Polymeric Flooring

AQUASTOP – E-96

Resources

Order Now